Bushwalk Australia

Are the units from TOAKS any stiffer that the cheap Chinese ones on eBay and other online sites?
I have an experiment in mind putting a skirt on a big pot to make boiling water and melting snow more efficient. I don't think that aluminium flashing would last long when exposed directly to the heat of an XGK or a Pocket Pocket

If the windshield is heating up, it's too close and is wasting fuel (and possibly will also result in the gas cylinder becoming dangerously hot)

Read the post again ribuck please.
I'm making a skirted pot, I just thought that the Titanium windscreen would make a great donor product but I have had very hot windscreens and ice cold gas cylinders all the time, I actually welcome the extra heat usually
But as for wasted fuel? The best gap between shield and pot is as small as gas flow will allow according to the expert Roger Caffin, 6 to 12mm sounds reasonable to me, open on one side for access to the controls naturally
There is a difference between a skirted pot and a windscreen and both can be used at the same time

Moondog55 wrote:Read the post again ribuck please.

OK, I get you now. I had thought the Titanium windscreen and the pot skirt were two different things that you were doing.